Designed for 3.5–5.5 GPM pressure washers. The Model 20 SS Bypass 3-Way Airless Foamer / Sprayer is a wash/rinse system for quickly diluting and applying three chemicals and rinsing through the same hose. This venturi unit draws and blends three separate chemicals or three different concentrations of the same chemical into the water stream to create an accurately diluted solution. The solution then flows through the hose and gun to the airless foam wand which draws in atmospheric air to create and project wet, clinging foam on to surfaces up close or at distances up to 25 feet with interchangeable fan and zero degree nozzles. Quick connect the fan pattern sprayer nozzle to apply non-foaming chemicals. Open the bypass ball valve to rinse at full volume and pressure.
Key Features
Designed for use with 3.5–5.5 GPM pressure washers
Applies 3 separate chemicals or 3 different concentrations of the same chemical
Draws chemical out of any container and accurately dilutes to the required ratio (7:1 and leaner)
Quick connect the airless foam wand to project wet, clinging foam
Foam increases chemical contact time and effectiveness, and provides visual confirmation of coverage
Foam impacts at a lower pressure than spray, allowing a pressure washer to be used on more delicate surfaces
Use the fan pattern foam nozzle for wide coverage or the zero degree foam nozzle for increased range (up to 25′)
Quick connect the fan pattern sprayer nozzle to apply a chemical spray
To rinse at full volume and pressure, simply open the bypass ball valve and quick connect your original rinse nozzle
Your equipment is protected because no chemical passes through the pump
Industrial-strength stainless steel construction, with chemical resistant wetted components, stands up to tough conditions and constant use – Built to last!
