Designed for 2.2–5.5 GPM pressure washers. The Model 20 Stainless Steel Hose End Airless Foamer is an airless foam applicator for quickly diluting and applying foaming chemicals. This venturi unit draws and blends chemical concentrate into the water stream to create an accurately diluted solution. The solution then flows through the airless foam wand which draws in atmospheric air to create and project wet, clinging foam on to surfaces up close or at distances up to 25 feet with interchangeable fan and zero degree nozzles.
Key Features
Designed for use with 2.2–5.5 GPM pressure washers
Projects wet, clinging foam which increases chemical contact time and effectiveness
Foam impacts at a lower pressure than spray, allowing a pressure washer to be used on more delicate surfaces
To rinse, simply quick disconnect the entire assembly and replace your original rinse nozzle
Use the fan nozzle for wide coverage or the zero degree nozzle for maximum range (up to 25′)
Draws chemical from any container
Your equipment is protected because no chemical passes through the pump, hose or gun
Almost no maintenance necessary: does not require pads, o-rings, or other wear parts
Foamer body is one solid piece of machined stainless steel – built to last!
Achieves chemical concentrations up to 7:1